PP Hollow Plastic Formwork is an energy-saving and green environmental protection product.

It is another new generation product after wood formwork, combined steel formwork, bamboo and wood veneer formwork and all steel large formwork.

It can completely replace the traditional steel formwork, wood formwork and square wood, save energy and protect the environment, and has low amortization cost.

Advantages:

1.Reuse more than 60 times

2.Waterproof

3.No need oil, easy install and remove. only tapping formwork can be fallen off.

4.No expansion, no shrinkage, high strenth.

5.Shorten construction period.

6.Bearable temperature: -10~90 degree

7.Anti Slip

8.Glass Glue can repair scratch on the surface

9.Plastic plug can repair the 12-24mm diameter hole

10.Rinse with Water will be clean

11.Rent and reuse in another construction site

12.Recycle at about half price in any plastic factory.

Method of Using:

1. The method of use is the same as that of the wooden formwork. The direction of the vertical ribs of the hollow building formwork forms a cross shape with the direction of the wood.

2. No need to apply mold release agent before use.

3. When the cast-in-place plate is used, the distance between the keels is 20~25cm, and the distance between the keels of the plate wall is 15~20cm.

4. The joint between the board and the board needs to be sealed with tape.

5. the length of the nail should not be too long, generally about 30 ~ 35mm.

6. Nail strength should be moderate.

7. When removing the mold, it is necessary to carry out the small piece from one end, and remove the template while dismantling the support to prevent large areas from falling, and do not let the corners fall perpendicularly to the ground.

8. The template can be mixed with wood plywood, bamboo glue board and other material plates.